message from Colin:
" I have not put a splash guard over the cross slide scale as I have had to trim back Saddle lock to clear mounting bolt.
Reader is also wrong way round so I do not hit end of scale at full movement of cross slide and room for cable run.
Also had to turn my own spacers around the bolts to hold reader in place as casting not machined where mounted had to shim to get rear scale mounted without curve.
It is mounted on a TIDA TD-6B lathe.
All appears to work fine, now to get used to it.
It should not take long, as all my mills have DRO. "
No comments:
Post a Comment