mTECH DRO-2L on Enco 111-1445 Lathe
The connection at the rear of the DRO
a view of both the X and Z axis installation
Z axis scale installation
This is the X axis (cross slide) scale installation
I have routed the cable below the cross slide.
==============================================
Enco Milling Machine 13x42
Enco Milling Machine - X and Y axis scale view
Cabling through the arm and to the DRO
Rear view of the connection to the DRO-2M
putting on an additional plate before mounting the X scales, to get a good surface.
Close-up of the X reader head
Installation of the Y axis scale
full view of the X and Y installation and the cable tie
Close-up view of the Y reader head
The
lathe is an ENCO 1442 and the
mill is an ENCO 13x42.
The systems are working properly. Good quality equipment. Excelent installation information.
I will recomend these readouts to all.
Thanks
Dave - Florida, USA
